Need help with mbuilder compile error

ShOOtMe · Post by **ShOOtMe** » Tue Feb 25, 2003 12:44 pm

When compiling, I get "exceeded MAX_POINTS_ON_WINDING". What is this? Is there a tut listing and/or explaining compile errors?

Balr14 · Post by **Balr14** » Tue Feb 25, 2003 11:33 pm

You have too many vertices along the same axis. The limit is 64. Look for some structure you have repeated along one axis. It could be vertical or horizontal.

ShOOtMe · Post by **ShOOtMe** » Fri Feb 28, 2003 6:35 pm

Balr14 wrote:You have too many vertices along the same axis. The limit is 64. Look for some structure you have repeated along one axis. It could be vertical or horizontal.

I have a single, tall, multi-level buildingin my map which I figure is the problem. I selected the entire structure, made selection detail, and figured that would cure the problem. It didn't help. How do I find the problem. All these problems........that's why I quit mapping RTCW. *SIGH*

Post by **Surgeon** » Fri Feb 28, 2003 6:55 pm

You need to break the big brushes up into smaller brushes

ShOOtMe · Post by **ShOOtMe** » Fri Feb 28, 2003 7:29 pm

Hmmmmmm.....I think I finally understand. I can have a wall, ceiling, or floor as long or wide as I want, but if it over X amount of grids in length I have to create it in panels instead of one large piece. Is that correct? What is the max gris length for a brush?