Finding a rogue texture

Zip · Post by **Zip** » Tue Jun 10, 2003 3:51 pm

I have been pulling my hair out trying to find a suitable texture for one of my buildings. I've tried quite a lot of them and finally decided to use boring old 'africawall' for the moment. My problem is I thought I made all the faces in question this texture but in the textures box (i have it set to display 'in use') the texture i was using before still shows up. I can't find the face with this texture on though. How can i find it and eliminate it? I tried the find/replace texture thingy but it didn't do anything

nuggets · Post by **nuggets** » Tue Jun 10, 2003 8:04 pm

apply the unwanted texture in question to a face of a wall, then select "Select from texture" then it'll select all the brushes using that texture, the 1st one being the texture you just added the second being the unwanted texture,

deselect the one you made and find the other one on the map, then if you still can't see it, it must be one of the textures inside the mitred edge (the one made to 45 degrees),

select caulk and then re-apply all the textures you'll need, if it still shows up, save and close radiant, then that'll get rid of the bugger, if it doesn't u have a radiant problem

Zip · Post by **Zip** » Tue Jun 10, 2003 8:08 pm

Nuggets! You're still alive! (well, maybe a little drastic of me, but nice to hear from you

)

It worked like a charm, thanks Nuggets

nuggets · Post by **nuggets** » Wed Jun 11, 2003 7:59 pm

although differentiating between languages has caused me many problems, actually drawing the damn levels doesn't, i'll still b here from time to time

Zip · Post by **Zip** » Wed Jun 11, 2003 9:41 pm

What other languages do you speak?