need help for mg nests (i already made asearch for this :p)

Choncey · Post by **Choncey** » Thu Aug 28, 2003 11:51 pm

ya
erm
i made my mg nest and all
and i entered the key/value maxyawoffset/50 thing so it doesn't point everywhere...but it doesn't work
is there something else i gotta enter??
thanx

General_DisArray · Post by **General_DisArray** » Fri Aug 29, 2003 3:01 pm

50 is the angle that it will allow you to rotate. are you still able to twist 360 degrees?

key: maxyawoffset
value: 50

is all you should need unless you want a smaller angle. try putting 25 or less and see if it constricts the movement.

crunch · Post by **crunch** » Sat Aug 30, 2003 4:05 pm

Also be sure that ONLY the mg42 is selected when you apply the k/v pair.

And remember, the value of 50 will give you a total movement of 100 degrees (50 to the left of center, and 50 to the right of center.

Kill Ya Later!