Is there a way to select just one face of a brush wothout hollowing it out? i would hope there is...cuz if not i gotta do ALOT of hollowing.
thanks
=BS=
Selecting one face
Moderator: Moderators
-
Axion
- Major General
- Posts: 683
- Joined: Mon Sep 29, 2003 5:14 am
- Location: Northern California
- Contact:
Hold down control + shift and then click on the face you wish to select. Easy, huh?
"The work of a thousand years is nothing but rubble."
- Dr. Carl Goerdeler (1943)
Visit my mapping site: http://www.freewebs.com/axion9
- Dr. Carl Goerdeler (1943)
Visit my mapping site: http://www.freewebs.com/axion9