how do i put up walls

Marines · Post by **Marines** » Thu Jan 01, 2004 8:42 pm

i cant figure out how to put up walls i can put the floor down but not the were can i find the unit thing on the level editor

Marines · Post by **Marines** » Thu Jan 01, 2004 10:43 pm

and how do i get my map to play i cant figure out to build my map in the map builder

omniscient · Post by **omniscient** » Fri Jan 02, 2004 2:41 am

left side is the height bar
compile in mbuilder then put the bsp in ur main/maps folder.

bdbodger · Post by **bdbodger** » Fri Jan 02, 2004 7:59 am

Drag the mouse in the 2d window and make a brush . control+tab to switch view to front or side view , drag mouse above the brush you just made to make it taller . Drag inside the brush to move it , the + or - keys will nudge it up or down . 1 key grid 1 , 2 key grid 2 , 3 key grid 4 etc etc .
The height bar on the left side also works to grow or shrink height of brush . Press the e key and drag the blue dots to move edges or the v key to move corner verteces press the same key again to exit edge or corner mode esc to deselect brush shift left click to select it again control + shift + left mouse to deselect one face or if nothing is selected to select one face for textureing .

Marines · Post by **Marines** » Fri Jan 02, 2004 5:02 pm

k thanks