Simple patch mesh

martijn_NL · Post by **martijn_NL** » Sat Apr 17, 2004 10:38 am

I want to make a nice camo net. I made i with simple patch mesh. But now the camo net is only visible on one side. Is it possible to make a simple patch mesh visible from two sides?

crunch · Post by **crunch** » Sat Apr 17, 2004 11:09 am

By default, regardless of shader properties, a patch mesh will only have texture o one side.

But, what you can do is make the mesh, adjust it where you want it, then copy it.

Once you've copied it, with the copy selectted, go to curve--->invert.

Then you have a texture visable from both sides.
But, you've also now doubled your mesh polycount.

Post by **Bjarne BZR** » Sat Apr 17, 2004 11:11 am

You can copy it and invert the copy. It works, but I'm not sure it is the right way... have you tried using a fence texture? That may work.

bdbodger · Post by **bdbodger** » Sat Apr 17, 2004 3:13 pm

What about cull none in the shader to make it draw on 2 sides ?

Krane · Post by **Krane** » Sat Apr 17, 2004 3:24 pm

Try, while creating the mesh, change the 2D view.