Clipping/Holes In Walls

Desert Eagle · Post by **Desert Eagle** » Sun Jan 12, 2003 7:25 am

I know not to use "subtract" to create holes into walls for windows or to create irregular shape holes into walls, so how do you clip correctly.....like cutting a triangle hole into a square wall?

As always any help would be appericated.

|RR| Desert Eagle
www.ravensraiders.net

mohaa_rox · Post by **mohaa_rox** » Sun Jan 12, 2003 7:42 am

Make a brush. To make a triangle, go to Brush, the select 3 sided. You may want to rotate it to a correct position. Then press the csg subtract (I recommend you do not use that).

Post by **jv_map** » Sun Jan 12, 2003 7:53 am

For a triangle, you usually have to split up a wall in two sides. Make a vertical split where you want the top of the triangle.

Then switch to front or side view, anywhere you can see the wall correctly. Make to more splits (one in each brush) and you'll get a sweet looking triangle 8) .

Desert Eagle · Post by **Desert Eagle** » Sun Jan 12, 2003 4:32 pm

Once again thank you. Whent he map is finished all that have helped will be given credit.

|RR| Desert Eagle
www.ravensraiders.net