hi
how do i save my building as a prefab, so i can put it in to my map
some 1 said that i have to highlight the building ?? & save it as a prefab
how do i highlight the hole of the building ?? do i have to selcet all the parts of the building or is there a quicker way to selcet the hole of the building ??
Hold Shift, and select all the brushes of your building.
If you need to select a lot of brushes, there is a faster way to select them in one time.
Make a huge brush around all the brushes you want to select (the brushes which need to be highlighted must be inside the huge brush). Then go to the tab "selection" and click on "select inside". You can see there are some more ways to select brushes in the selections list.
If all the brushes are selected, then you can save them as a prefab.
At0miC wrote:Hold Shift, and select all the brushes of your building.
If you need to select a lot of brushes, there is a faster way to select them in one time.
Make a huge brush around all the brushes you want to select (the brushes which need to be highlighted must be inside the huge brush). Then go to the tab "selection" and click on "select inside". You can see there are some more ways to select brushes in the selections list.
If all the brushes are selected, then you can save them as a prefab.
thanks Atomic your an Ace.......
just more thing ? then all i have to do is go to load prefab click on it ,
my building will then be loaded in to my map.
so i can put it in to my map
your an Ace.......
