error when compiling a breakthrough map !!!!!

lizardkid · Post by **lizardkid** » Wed Jul 13, 2005 10:26 pm

then logically it'd have a different error. what's it say in console when you run it in BT?

Mbuilder just automates the process, It doesnt do anything different than compiling like you did before

carlos_pagano · Post by **carlos_pagano** » Thu Jul 14, 2005 4:25 am

Yeah, yeah guy !! I think that's it !!! Spearhead and BT engines can load AA maps ... But the MBuilder can ONLY deploy an AA map, just !!! If you need a SH or BT map, you should compile with the tools of SH SDK ONLY, right ???? Anyway ... I have another question, why the light/vis compiler does not work ??? The process start but has no end !!! what a f...k !!!

lizardkid · Post by **lizardkid** » Thu Jul 14, 2005 4:37 am

No, trust me, i've compiled both BT and SH maps with MBuilder.

Light and Vis take a looooong time, longest recorded was like a week (correction?).

Post by **Rookie One.pl** » Thu Jul 14, 2005 5:34 am

carlos_pagano wrote:CM_LoadMap: maps/test_xxx.bsp has wrong version number (21 should be between 19 and 19)

This is the error. It always appears if you're trying to run a SH map in AA. This clearly states that the version number of the map is higher than the version number supported, which in turn means the map is meant for a newer engine (meaning the expansion packs).

carlos_pagano · Post by **carlos_pagano** » Tue Jul 19, 2005 7:40 pm

Men, this error above appeared when i loaded the map in the Spearhead, trust me !!!! And not in the AA !!!! That's why i'm curious...