spiral staircases

neillomax · Post by **neillomax** » Sat Aug 13, 2005 7:12 pm

How in the hell do you make spiral staircases ?[size=18][/size][size=12][/size]

At0miC · Post by **At0miC** » Sat Aug 13, 2005 7:26 pm

Well, you need to have some feeling to make it correctly. I think u could better try yourself, use the Clipping Mode (control + RMB) and the DragEdges Mode (E). You could make a cylinder first (as a tool) then be sure what the centre would be (could be a pole) then try to make the stairs between it. The width of one stair should be small on the center and wide on the outside.

good luck

Anyway I've found a funny tool, you can generate a prefab of a spiral stair on this site:

http://www.samurajdata.se/~ra/stair.php

neillomax · Post by **neillomax** » Sat Aug 13, 2005 8:05 pm

Thanks alot....its a good start

PKM · Post by **PKM** » Sat Aug 13, 2005 9:17 pm

sorry to do this to you but i know there's a prefab for one out there, just can't remember where i saw it.

ViPER · Post by **ViPER** » Sat Aug 13, 2005 10:13 pm

http://www.samurajdata.se/~ra/stair.php

hogleg · Post by **hogleg** » Mon Aug 15, 2005 4:59 pm

I use these Quake 3 prefabs a lot. You just need to retexture em.

Prefabs

There are several spiral stairs built fer ya

neillomax · Post by **neillomax** » Mon Aug 15, 2005 10:27 pm

Lots of goodies there...thanks everybody