Surface Properites Question

SniperWolf · Post by **SniperWolf** » Sat Feb 03, 2007 12:25 pm

If I check the box that says "nomarks" in the Surface Properties Box will that make it so there would be no bullet holes on that surface?

I have some targets that disappear when shot but you can see the the bullet marks after it disappears. I don't want to see the marks.

neillomax · Post by **neillomax** » Sat Feb 03, 2007 7:55 pm

I don't know about that, but what would the one above it do ? I don't know why you'd not want bullet holes, but you can disable them in the game console.

Post by **Rookie One.pl** » Sat Feb 03, 2007 8:25 pm

@Neillomax: OMG.

Please, do read the posts.

SniperWolf wrote:I have some targets that disappear when shot but you can see the the bullet marks after it disappears. I don't want to see the marks.

@SniperWolf: it would disable the bullet holes on that surface altogether. Why don't you move the target to an alternate location where it can't be seen instead of hiding it?