Mohaa SDK - Selecting everything

Cobra · Post by **Cobra** » Sat Jun 09, 2007 12:44 pm

Anyone know how to select the entire map? Is this possible in the SDK? ( For example, to save it as prefab. )

Imagination · Post by **Imagination** » Sat Jun 09, 2007 12:51 pm

Long time since I played with radient but I believe you draw a large brush over the complete map and then select inside, this should highlight all the brushes etc and then save to prefab.
If prefabs contain too many brushes you will have great difficulty in moving it as a whole - usualy resulting in a crash.
This is off of memory so I may be mistaken on some points.

Cobra · Post by **Cobra** » Sat Jun 09, 2007 12:57 pm

Indeed, this was working for me. Thanks Imagination.

But replacing the prefab into a map is leading to a crash indeed, to bad that this isnt possible in the quake editor.

tltrude · Post by **tltrude** » Sat Jun 09, 2007 4:33 pm

Use the filters to remove stuff from your view. Then save what's left. That way you can breakup the map into smaller prefabs.

ViPER · Post by **ViPER** » Sat Jun 09, 2007 4:44 pm

yea - large prefabs are unwieldy. Often crashing radient when manipulated.