.Map :: MoHAA Mapping

bdbodger wrote:go to preferenced and uncheck "use quake3 .map format"

Are you sure you did that ? That is the only thing other than filters that can do that .

Please tell me if its wrong...



Lib

this is what mine looks like. Don't know if it will help

change or deselect:

Brush scale 0.25

No update 2d

Models in wire frame

Show non shader images

Snap camera in 2d view

hope you save alot.......... auto save not on

the print is too small. Does it say on the top bar if the filter is on?

Your first screenshot is blured, and I can't tell if you have filters on or not. But, go to View > Filter and click on "All".

The Filter isnt on

I think I have to give up this map....

Lib

You could maybe send the .map or .bak file to someone here. That way they could take a look, and see if they can't figure something out. No reason to just delete all that work without trying everything first.

I see by your settings that you have "snapshots" turned on. That means there are multiple copies of your .map file going back to when you first started the map.

Have you tried copying the entire map to a new map?

Yes I have tried to copy it....it just freezes and then it crashes

I have desided to leave this map for a while...I have other idears that I cant wait to build

Thanks a lot for the answers

tltrude wrote:I see by your settings that you have "snapshots" turned on. That means there are multiple copies of your .map file going back to when you first started the map.

Have you tried copying the entire map to a new map?

You don't need to copy anything just use one of the snapshots .

Ok thanks...I Try that