.Map :: MoHAA Mapping

i just tried the leaked thing ... and i down understand it i mean like a see this red line afterclick on point file but i dont know what to do after... i could send you my map if you want ????
thanks
costa

start to follow (with the camera) the red line at the point INSIDE the map's skybox where it is starting. Sooner or later it will leave the skybox into the void (the OUTSIDE). The place where it runs through the skybox is the leak. This place is either a gap, where there isn't anything, or the red line runs through a brush or a patch mesh or LOD terrain. Now, LOD terrain and patch meshes do not 'seal' the skybox, so u will have to put a structural brush behind/below it to close the leak. If it was a brush where the red line is passing, this brush is either detailed (doesn't 'seal' the skybox) or the brush is textured with e.g. a transparent texture (doesn't 'seal' the skybox either).
Try to find where the leak is and to close it. The leak is closed, as soon as the compilation does no lin file, which will result in the fact that no pointfile (no red line) can be loaded.
If everything fails, post again!

sorry i took time to awnser back
hey wacko i triyed what you told me but i dont understand can i send you the map instead ???
thanks
costa

costa wrote:sorry i took time to awnser back
hey wacko i triyed what you told me but i dont understand can i send you the map instead ???
thanks
costa

ok, zip the map and send it