Page 2 of 2
Posted: Tue Aug 10, 2004 4:55 am
by hogleg
Thx,
Just extend that brush a little beyond all door edges?
and this thin brush is completly inside the door and beyond the edges?
right?
edge
Posted: Tue Aug 10, 2004 5:12 am
by tltrude
Some mappers say to overlap the area brush, but I don't and it works fine. Yes the brush has to be hidden when looking at the closed door from both sides. So, it has to be thinner than the door brush. To make sure it seals the door opening , you can filter out entities. Also, filter out detail and patch mesh to make sure the room is structurally sealed.
map times
Posted: Wed Aug 18, 2004 11:49 pm
by Myth
LOL
You will all laugh now,
My map, Knight Templers Bridge (Mission One) took 7 days to compile
okay, you can all stop laughing now !!
Regards
Myth
Posted: Thu Aug 19, 2004 11:43 am
by m4rine
wow you need detail brushes in that map lol
Posted: Thu Aug 19, 2004 1:54 pm
by MasterMind
WOW!
Posted: Fri Aug 20, 2004 1:02 am
by tltrude
I just tried compiling a small test map with my new Dell 3.4Ghz computer. The DOS compile screen blinked on and off so fast that I was not sure it even compiled, but it did. That map took about 5 minutes to compile with my old computer (Dell 733Mhz).
Posted: Fri Aug 20, 2004 1:48 am
by Chaplain_GT
Hiya, Fellas.........
Once again I'd like to thank you for your advise. I've used the detail brushes & the 'no draw' texture. Compile time has been cut down to about 1.5 hrs!!!! WHAT A DIFFERENCE!
The folks over at
www.crazycampground.com are going to run it this weekend to test it on a server. If all goes well, I'd like to know where I could upload it for more people to use. Any suggestions?
