add_on item

neillomax · Post by **neillomax** » Sat Jul 16, 2005 7:26 pm

I just put a vehicle in my map from the add_on section in the 2d view box. Most vehicles you add, you can move close to them and they appear. The item I spawned stays a blue square, no matter how far or how close you are. I want to be able to "wrap" this vehicle so it will be bulletproof, but still have access to parts of it, therefore, cannot completely encase it. Is there a way to make this vehcle showup in radiant so I can do what I want ?

Post by **jv_map** » Sun Jul 17, 2005 6:13 am

In preferences try increasing the model cull distance. Also make sure the model isn't corrupt (check for errors at bottom of screen).

bdbodger · Post by **bdbodger** » Sun Jul 17, 2005 8:18 am

The spearhead models use to do that you had to be inside the box close to the point of origin to see them . That was mainly the larger models . Are you useing mohaa tools intead of the SDK for spearhead that too may make the models look like that .

neillomax · Post by **neillomax** » Sun Jul 17, 2005 7:14 pm

Yup. probably the mohaa tools thing. changed model cull setting to 1512, everything that was already there showed up sooner than normal.
......................thanks