Compiling Error?

|RR| Desert Eagle · Post by **|RR| Desert Eagle** » Sat Jan 04, 2003 11:30 pm

After 22 Hours, I have finally got mapping down and MOH Radiant. Now I am using MBuilder to compile. Goes along just fine until this:

====== Initial Lighting ======
95 light emitting surfaces
0% complete. 0 hours 0 minutes 0 seconds remaining.

and stays there, for minutes and minutes, and even waited for up to 30 minutes.

So anyway loaded up the BSP and ran around on map, and lighting was horrible.

Any Help would be appericated, Thank You

|RR| Desert Eagle

www.ravensraiders.net

Rommel · Post by **Rommel** » Sat Jan 04, 2003 11:39 pm

When you are compiling the map, depending on your lighting selections, it can take up to and over an hour. Most of the time you can expect some fairly long times for the light to compile, depending on the complexity. Best advice - let it sit there and build. Then when done, you can see if the wait was worthwhile for the lighting

|RR| Desert Eagle · Post by **|RR| Desert Eagle** » Sat Jan 04, 2003 11:55 pm

Thanks for the information.