.Map :: MoHAA Mapping

Before i hit CSG Subtract (below)


After i hit CSG Subtract (below)


so does anybody know why when i subtract it it outlines a box instead of the archway itself??

Don't use csg subtract. Make the arch the way you did. Then make small rectagular brushes above, and into the arch. When the brush is highlighted, select "e". After doing that, click on one of the corners, then click the other side of the brush a short ways up. This will create a sort of triangle. Several of these will work on each side of the arch.

never mind.......... read this

/t.php?id=16

Yeah if at all possible don't use CSG subtract. You would be better off building all the brushes yourself.

Agreed, I never use CSG subtract, it's an easy way to mess you up, even if you are a pro at this.

i still dont understand :O -

i dont understand this tut!!!!!!!!

It is ok if the patch overlaps brushes. Just make a rough hole that is about the same shape. In other word, put some triangles in the corners.

Basically it says to make small brushes around and into your arch. Having done that, with the brush selected. hit the letter x.......... click on one corner of the brush, and then click the other side to make the brush "cut" itself off........ on an angle......... to follow the arch. Do it all the way around the arch.


Practice.......... make a brush............. while it's selected

hit the letter X

click on one side of the brush.... I think a blue dot appears.

click on the other side of the brush......... slightly higher.........

brush should cut itself on an angle......... hit enter and deselect

tltrude wrote: Just make a rough hole that is about the same shape.

well how do the mappers make arches like i did and put them in a wall like i was doing without an outlined box. theres this map called fortwreck and it has an arch like this and which i an trying to build a similar map to fortwreck

neillomax wrote:
Practice.......... make a brush............. while it's selected

hit the letter X

click on one side of the brush.... I think a blue dot appears.

click on the other side of the brush......... slightly higher.........

brush should cut itself on an angle......... hit enter and deselect

thanks for info i trying to do that now

Put some triangles in the corners. To cut a brush, use the clipper tool -- looks like three conneted dots on the tool bar.

superturk wrote:

neillomax wrote:
Practice.......... make a brush............. while it's selected

hit the letter X

click on one side of the brush.... I think a blue dot appears.

click on the other side of the brush......... slightly higher.........

brush should cut itself on an angle......... hit enter and deselect

thanks for info i trying to do that now
sometimes i dont comprend stuff and even sometimes stuff that i know

Yes, it is key X, or the button with three dots. To use it, do the dots in a clockwise direction around the brush. If you like the cut, hit enter, if not hit escape and try again. If it cut off the wrong part, hit the key to the left of key 1 (~) and it will switch parts.

o thank u tltrude

yay i did it all i did was i made a brush and went to curve>primitives>cylinder and it was an cylinder and i draged the cylinder to the wall and subtracted it and there was the top part of arch
and made a rectangle to do the bottom part like this