.Map :: MoHAA Mapping

Hi, im a newbie on this forum so i don't really know this forum so don't blame me

So i wanted to convert a SP map (not by converting .bsp to .map). Everything was fine : scripting, doors, items, etc. But the Info_Player_Allied is not working, i keep spawning at the same spot in SP

Can someone help me please?
Thanks

spawn info_player_allied origin "-5222.41 396.12 -309.88" angle "-1.04 -35.39 0.00" "targetname" "bootcampsoldiers1"
spawn info_player_allied origin "-4695.76 -751.24 -309.88" angle "3.49 113.75 0.00" "targetname" "bootcampsoldiers2"
spawn info_player_allied origin "-4696.25 667.42 -309.88" angle "4.71 -114.66 0.00" "targetname" "bootcampsoldiers3"
spawn info_player_allied origin "-5483.78 -797.12 -309.88" angle "5.94 75.50 0.00" "targetname" "bootcampsoldiers4"
spawn info_player_allied origin "-5485.14 719.75 -309.88" angle "2.92 -81.45 0.00" "targetname" "bootcampsoldiers5"
spawn info_player_allied origin "-4415.02 -444.34 -309.88" angle "1.04 27.58 0.00" "targetname" "bootcampsoldiers6"
spawn info_player_allied origin "-4324.24 579.88 -309.88" angle "-0.76 -58.04 0.00" "targetname" "bootcampsoldiers7"
spawn info_player_allied origin "2323.27 -2580.07 -387.88" angle "0.75 91.07 0.00" "targetname" "bootcampsoldiers8"
spawn info_player_allied origin "3036.36 -2578.60 -387.88" angle "1.51 89.56 0.00" "targetname" "bootcampsoldiers9"
spawn info_player_allied origin "3742.01 -2579.80 -387.88" angle "0.47 90.41 0.00" "targetname" "bootcampsoldiersA"
spawn info_player_allied origin "4433.91 -2585.50 -387.88" angle "1.41 89.87 0.00" "targetname" "bootcampsoldiersB"
spawn info_player_allied origin "5141.79 -2605.66 -387.88" angle "1.51 88.46 0.00" "targetname" "bootcampsoldiersC"
spawn info_player_allied origin "5806.45 -2596.62 -387.88" angle "1.60 89.31 0.00" "targetname" "bootcampsoldiersD"

I assume you haven't found an answer yet so i'll give it a shot..

The reason these spawns don't work, is you have to use "angles" for values "x y z"-axis or "angle" for just the y-axis, which is the important one.
Also, presuming from the origins and angles it looks like you used "viewpos" in console to get these values. Remember viewpos gives values at camera-height, but spawning spawnpoints use ground-level height. In other words, if you hadn't done so already, decrease all your z values by around 80 units to spawn touching the ground. If all of these spawns were somewhere inside, that could have also been a reason why the spawns didn't work.

Fixed it for you: