I followed the tutorial on the moh design site but i get a problem ,
i can't save the terrain that i make , after i've made my hills and stufff , i save my map but then when i load it up again , the hills made with LOD have disappeared ??? Anyone know how to fix this ? What the dillio ?
-- Mickey C --
LOD TERRAIN PROBLEM
Moderator: Moderators
-
Shadow Knight
- Lance Corporal
- Posts: 24
- Joined: Mon Jul 01, 2002 7:53 pm
- Location: Tulsa, OK
You might see if (at the very top where it says your map's name
and it's saved location) you have any filters on. Like terrain or any-
thing else. Go to your menu and look under VIEW, then FILTER, and
see if terrain is checkmarked. Take it off............
and it's saved location) you have any filters on. Like terrain or any-
thing else. Go to your menu and look under VIEW, then FILTER, and
see if terrain is checkmarked. Take it off............
Last edited by Shadow Knight on Sat Jul 20, 2002 4:53 am, edited 1 time in total.
The Knight gives way to Shadow
lod
Try this:
Look at your map and hold the shift and control keys down. Click on the terrain where your hills should of been. A white surface should appear for that 512 by 512 block. if it shows hills then it will show up that way when you compile it. I have that same problem and it's a pain in the butt trying to figure out what my terrain really looks like because MOHradiant will not display it correctly.
Look at your map and hold the shift and control keys down. Click on the terrain where your hills should of been. A white surface should appear for that 512 by 512 block. if it shows hills then it will show up that way when you compile it. I have that same problem and it's a pain in the butt trying to figure out what my terrain really looks like because MOHradiant will not display it correctly.
Tom Trude,
