.Map :: MoHAA Mapping

When I was making my underwater map i had a few problems. First off this

/forum/viewtopic.php?t=2266
Check out the picture in the game
My door looks like that when I try to open it. Its actually two doors put together to open at the same time. Instead it is doing that. Yes I put the origin into where I want the doors to turn. But that doesnt work for somereason.

-----------------------|-------------------------
|O.........................|.........................O...|
|R.........................|..........................R..|
|I..........................|..........................I...|
|G.........................|..........................G..|
|I..........................|..........................I...|
|N.........................|...........................N.|
|...........................|..............................|
|...........................|..............................|
|...........................|..............................|
|...........................|..............................|
|...........................|..............................|

That what my door looks like that are two doors but they open from this

_________________(Top view)

and supposed to look like this when open

......../.....\......... (top view)
....../.........\.......
..../.............\.....
../.................\...
/.....................\.
.........................

But instead it opes like this
(top view)

1. ____________ from this to

2. \.............. this.
.....\.............
.......\...........
.........\.........
...........\.......

Your door(s) consists of 4 brushes in total?

Well two brushes are the two doors. Plus I have two origins for the two doors. When I tested this kind of mapping in a test room where I made a bunch of stuff I wanted to see what it would look like in a game that im going to make. And the doors opened just fine no problems there. but when I made the same exact thing in this map and compiled it rotated in the middle.

If you select a door and press ctrl + e, is the corresponding origin brush automatically selected?

corresponding origin brush automatically selected?

Whats that?

To make a door, make a brush for the door and another one with origin texture. Select both and turn this into a func_rotatingdoor.
If you select then one of these two brushes and press Ctrl+e, both should become selected.

Have you selcted all four brushes for turning this into a func_rotatingdoor?
You must make each door seperatly and the engine will know that they belong together

So even the Origin has to be a rotating door function?

Not the origin brush by itself but the one brush or the group of brushes that are the door plus the origin brush ALL TOGETHER are one func_rotatingdoor

hehe lol

i said "So even the..." that means even the origin brush? Ok you answered my question thanks. But how come it worked before? I never made the origin a rotating door func.

Ok. so it should work now? I hope it does. BTW. Wacko thanks for the glass textures Im using those as a few of my walls. I will release a demo of my upcoming MP map so you guys can add your two cents in. If everything goes as planed you this would be my first released map.

So even... : My English is probably to bad for this: Read it twice, don't know

Looking at the ASCII-artwork in your first post:
These are TWO doors! Again: They have to be build seperatly!
Make the left wing: Turn one door brush plus one origin brush BOTH SELECTED into the 1st func_rotatingdoor, then make the right wing the same way or copy the left.

Ok I got it. LOL

Yarik wrote:thanks for the glass

No prob! It's more or less not my but a .map texture, because without this forum I would never been able to make anything in or for MOHR.

Yarik wrote:So even the Origin has to be a rotating door function?

Duh......yes!