Page 1 of 1
fence in large when i press ctrl+f
Posted: Thu May 01, 2003 5:25 am
by {=SuperFly=}
am i not ment to push crtl+f on the a fence that is like grates why does it inlarge not get smaller?
Posted: Thu May 01, 2003 10:06 am
by Angex
ctrl + f == fit texture to face.
It will shirnk or stretch a single "tile" to fit the entire face of the brush (No tesselation) .
Posted: Thu May 01, 2003 11:40 am
by mohaa_rox
Try to coordinate the texture by pressing "s".
Posted: Thu May 01, 2003 10:34 pm
by wacko
Ctrl+F is fine, even for long brushes:
You'll get the correct value for e.g. the vertical scale and then you can enter the same value for the horizontal scale to get it undistorted again 8)
Posted: Fri May 02, 2003 12:06 am
by nuggets
if you want to apply a texture to something like longer windows, and it needs applying with CTRL + F but u want it to appear side by side twice
--------------
|...............|
|...............|
-------------- if this is the basic texture you want for the window but it gets stretched too much over a window like
----------------------------
|.................................|
|.................................|
---------------------------- this, then make the window the same as the 1st size (exactly half of the second 1, use CTRL + F, then enlarge the brush to it's original size
you will then see two identical perfectly fitting textures side by side (but only over 1 brush)
