taholland

The_Grass · Post by **The_Grass** » Mon May 12, 2003 2:46 pm

My question is I use the normal MohRadiant ,and have Mohaa and Spearhead installed now my problem ?
I want to use the "taholland\Roof texture because it stays in my Texture list for MohRadiant but when I compile the map then my taholland\roof texture is not in the compiled map, it black with yellow , did someone got a solution for this.

I need those Roof textures , otherwise my farm wil not look as good without it.

Ps I can see it in MohRadiant but not in the compiled map.

The_Grass Aka Ruud Grasman ( NL )

SNap007be · Post by **SNap007be** » Mon May 12, 2003 3:23 pm

I suggest u make sure u get a MOHAA skin, not SH and make sure you dont have more than 1 brushes in a place, like try to select the roof brush and click delete. Try to run your map from SH as well.

Post by **jv_map** » Mon May 12, 2003 3:35 pm

It might be a good idea to remove custom pk3s as well.

Slyk · Post by **Slyk** » Mon May 12, 2003 4:54 pm

Just run the map in Spearhead.......your files are probably fine. AA doesn't read the SH mainta/ folders so ANY map with SH textures will show the black/yellow grid when run in AA. The only way around it is to transfer those textures into AA......and that's a headache. Either design it without the SH textures for AA and SH owners, or go with SH and 'damn the poor bastards' without SH.

BUT, to make everyone happy, take the time and add the SH textures to a new folder and put it in the main/textures folder. Then everyone will get it via your pk3.

The_Grass · Post by **The_Grass** » Tue May 13, 2003 12:16 pm

OK Slyk that's the answer I needed , Thanks a Lot

I will try to come back on this.