Page 1 of 1
Importing from Autocat
Posted: Mon May 19, 2003 8:13 am
by Sjappo
Does anyone know if this is possible. I can get my hands on the autocat drawings from the building I work in. I think it would make a wonderfull map.
Or it should be fun to have a fragfest with my co-workers inside the office building
Posted: Mon May 19, 2003 8:26 am
by Surgeon
As far as I know its not possible.......anyone know different ??
Oh and welcome to .Map
Posted: Mon May 19, 2003 11:21 am
by wacko
me neither
best i know is make blueprints with grid in AutoCAD and start mapping.
Even if an import was possible, the structure and way of building is so different in AutoCAD, that you had probably more work with correcting than with a complete rebuild in MOHRadiant.
Posted: Mon May 19, 2003 11:28 am
by Sjappo
I was afraid of that. Thanx anyway. I'll do it the old fashioned way. By hand
O well.
Posted: Mon May 19, 2003 1:28 pm
by Shifty
I use autocad at work - I think it goes into 3D Studio Max but not mohrad
Good job though Cos thats all i'd be doing at work