Page 1 of 1
ok can you solve this one?!
Posted: Mon May 19, 2003 1:10 pm
by Triicky
ok i made my ladder it works but there is all this yellow stuff (check link)
what should i do to get rid of it?
http://www.dodstudios.net/uploads/uploa ... yellow.jpg
Write back asap!
TRIICKY
Posted: Mon May 19, 2003 1:46 pm
by Bjarne BZR
Thats an error that happens when you have too many brushes ( the steps ) intersecting a single face ( the ladder rail ). Cut the ladder rails into smaller sections ( say 5 steaps each ) to get rid of this problem.
Posted: Mon May 19, 2003 1:54 pm
by Triicky
Cheers m8
Posted: Mon May 19, 2003 4:56 pm
by Slyk
If your ladder isn't crazy long, your problem could also be that one or more of the rungs are conflicting, i.e. inside eachother. Also, select all the rungs and rails and press 'ctrl+g' to snap them to the grid. You can get the same yellow/gray/black stuff from unaligned/snapped brushes.
