Why does this door do this?

Silent_Death · Post by **Silent_Death** » Sun May 25, 2003 10:28 pm

When I try to open the door all it does is move back a bit?! How can I fix this?

tuffstuff7 · Post by **tuffstuff7** » Sun May 25, 2003 11:27 pm

is it a function>roataing door? if so make sure in the entity box the the angle is set properly play with the angles till you get used to the way they face.
And, if you want the door to open both ways do the key/value

key---alwaysaway
value-1
also,your orgin brush should be on one side touching the jamb and over lapping just a little on the door

Silent_Death · Post by **Silent_Death** » Mon May 26, 2003 12:43 am

How do I set the angle? God this is so hard! I'm never going to be able to make a door.

Yarik · Post by **Yarik** » Mon May 26, 2003 1:35 am

in the Texture menu click COMMON
Once the textures load. There will be a texture called ORIGIN. It will be red.
Take that texture and make a brush that will act as the hinge

Now once you have that. Make sure its still high ligthed then right click and do the same thing again func-->Rotating door.

[/img]

Now you should see this