.Map :: MoHAA Mapping

I try to put another table for cardgame.scr, works OK but the chair is out of scene and the players(card) are sitting in the air

did u use animate/furniture/cardtable i think?

Maybe you need to scale the table model up a little.

I looked at the tik for the table nothing special about it maybe it is because the table you used is solid . I used a ai with targetname enemyspawner in a map and didn't notice in the editor that he was standing in some barbed wire . When he spawned he was in the air above the wire until I shot him . It maybe a game thing so two models don't intersect or over lap thier bounding boxes maybe makeing the table a notsolid script_model might work ?

Exactly, you need to make a non-solid table (making it solid later if nessecary), or a pratially solid table as suggested in the cardgame.scr.

cardgame.scr wrote:Create a clip brush that fits it, and then move it in on the x and y by about 4 units from each direction (basically creating a mini table in the table because if the table was solid the AI would get stuck on it).

Thanks for all