.Map :: MoHAA Mapping

Okidokie,

I have made a ladder in my map and its giving off a wierd line of 2 colours.

Picture:


Please could you help me on correcting this

Thanks for your time.

- Ricci[/img]

the sides of the ladder are touching too many surfaces (the handles). seperate the handles from the sides or somethingl

Ok, ill try it

Thanks

- Ricci

Nope m8

I hate to be a spoil sport but,

My handles are not touching anything, not even the wall behind.

Thanks though

- Ricci

Never seen it in green/yellow... cool!

I would cut the ladder in two pieces half as long and I also would replace the handles with just one brush (5 sides nodraw, 1 side a masked texture like general_industrial/ironbar or algiers/railing_natestah both turned by 90 deg).
This error is commonly produced - like Alcoholic said - by a brush's face (here the inner face of the long vertical ladder pieces)with too many vertices touching (all the little horizontal brushes), and above should help.

interesting, try redoing it again.

If you make the rails wider than the rungs it will fix it. I like using 2 X 4 rails and 2 X 2 rungs (units). So, looking from the side, the rails are 4 units wide and the rungs are 2 units wide and centered on the rails.

Thanks for your help people, I fixed it just like tltrude mentioned.

- Shortricci