Page 1 of 1
PIPES AND WIRES?
Posted: Thu Sep 19, 2002 3:29 am
by Qages
IN VARIOUS LEVELS I SEE VERY SMALL WIRES, AND THEN I SEE ROUND PIPES, HOW DO I MAKE THOSE? WAND WHAT TEXTURES ARE THEY?
Posted: Thu Sep 19, 2002 5:50 am
by tltrude
Type metal in the text box at the top of the editor window.
Posted: Thu Sep 19, 2002 7:47 pm
by UBER_SOLDAT
the wires are something like wires_parallel. to make pipes, load the general_industrial textures, and chose one of the pipe ones. Make a brush about 16x16, or however wide you want the pipes. Go to the curve menu, and choose cylinder. Then resize it etc. To make a bend in the pipe, copy the pipe, and resize it to about 32-64 long. then go to curve/bend mode, and bend the pipe 90' and then line it up with the other pipe. If the textures looks too stretched, press 's' and lower the vert/horiz size.
Posted: Fri Sep 20, 2002 12:25 am
by Qages
general_industrial will crash the editor if i load it
Posted: Fri Sep 20, 2002 6:03 am
by kdja
run a check disk.
the files get corrupted very easily or defragment your hard drive.
kdja