a caulk wall in my map

BLUES_MAN · Post by **BLUES_MAN** » Fri Aug 08, 2003 12:36 pm

Hey all, anyone know what this is? I have a wall, bout 1 unit thick and it runs the whole length of the grid, and same with the hight, it just appears when I load radiant. thanking all in advance.

Post by **Bjarne BZR** » Fri Aug 08, 2003 12:41 pm

I had this some times as on the Vemork Factory map... I just deleted it and saved it again...

Alcoholic · Post by **Alcoholic** » Fri Aug 08, 2003 10:33 pm

thats weird... and its a caulk wall?

BLUES_MAN · Post by **BLUES_MAN** » Sat Aug 09, 2003 7:27 am

Yippers, its the size of the grid, but it goes vertically straight up and down, and is also as wide as the the grid as well, always uses the caulk texture, just started happening recently. Thanks for the replies.

tltrude · Post by **tltrude** » Sat Aug 09, 2003 12:34 pm

It is probably an "evil poly" that is part of a caulk brush. You can get rid of it with Bobz Tools (plugins for the editor). Send me an e-mail if you want them.

Daniel Radcliffe · Post by **Daniel Radcliffe** » Sat Aug 09, 2003 10:24 pm

Ive had this occur too, it happens when you use the CSG subtract tool. Try using the clipper tools instead.

Im not sure as to why exactly it occurs, i just know it does. But if you dont use the CSG subtract tool you should stop getting these walls.

BLUES_MAN · Post by **BLUES_MAN** » Sun Aug 10, 2003 6:35 am

Thanks for the info folks, so to see if Im get this right, deleting the walls won t do anything right? they re a pain for sure, now all I gotta do is learn how to use the clipping tools,lol

Daniel Radcliffe · Post by **Daniel Radcliffe** » Sun Aug 10, 2003 10:02 am

Thats right yeah.

.Map :: MoHAA Mapping

a caulk wall in my map

a caulk wall in my map

Evil poly