Page 1 of 1
Another qustion but not the last
Posted: Mon Jan 05, 2004 4:11 pm
by {UDT}OS3.Barney_Fife
I did not see the in the forms. Is there a way to CSG Subtract with out makeing lines through your wall. Ex. when you make a hole for a wall on the top of the door it it make a line through your wall from one side to the other. I thought there was but I dont rember.
brush
Posted: Mon Jan 05, 2004 4:59 pm
by tltrude
CSG cuts the wall brush up into smaller brushes to make the hole. It doesn't always pick the best way to cut it up, so sometimes it is better to just do it yourself.
Clone the original wall and move the edge over. Then move the edge of the original over, clone it again and move the edges to create the top of the door opening. Moving the brush edges, instead of moving the whole brush, keeps the texture aligned--if the texture locks are on. Be sure to caulk the new (hidden) brush faces.
Posted: Mon Jan 05, 2004 5:03 pm
by Bjarne BZR
No, there is no way to avoid it.
By CGS subractting a door from this:
...you will get this:
Code: Select all
_______
| |
|______|
| | | |
--- ---
...but what you want is this:
Code: Select all
_______
| |
| ___ |
| | | |
--- ---
...however that wont work, but if you make your wall manually, you can make this ( if that is better for you ):
Code: Select all
_______
| | | |
| ___ |
| | | |
--- ---
Am I beeing of any help at all, or am I just messing with your head?
Basically, you cant make a brush with a "hole" in it ( like the mouth of a packman ), you must construct such an object from multiple brushes.
Posted: Tue Jan 06, 2004 9:26 am
by {UDT}OS3.Barney_Fife
Hmm...ok thanks for the help and I get what your saying.
Posted: Wed Jan 07, 2004 5:22 am
by omniscient
well, couldnt u make a multi sided brush and vertex edit it to make a hole?
Posted: Wed Jan 07, 2004 8:03 am
by Bjarne BZR
no
Posted: Wed Jan 07, 2004 8:53 am
by wacko
Bjarne BZR wrote:no
just to give some explanation: brushes in MOH (or in any other game with Q2,Q3,HL engine) MUST BE convex, i.e. all 'interior' angles of a brush must be smaller than 180?.
Vertex editing can result in the opposite, a concave brush, which will however cause errors.
Posted: Wed Jan 07, 2004 12:24 pm
by Bjarne BZR
Thanx Wacko
