.Map :: MoHAA Mapping

I made this sliding door with a window in it and when I tested it the door went straight to a wall, but I want it to stop before or when it hits the wall...
I've searched the forum, but I didn't find a solution...

I Think the pics explain it all....


http://users.skynet.be/se100025/door1.jpg


http://users.skynet.be/se100025/door2.jpg

Is there a way to fix this?

pics dont appear

M&M wrote:pics dont appear

that's strange, I can see them, maybe, the server was down... Anyway I put the URLs in too...

give the func_door a key/value of lip/##
## is the number of units u want it to stop earlier minus 8
normally a door slides as far as it is long minus 8, which is because the default lip value is 8.
so:
if it slides 32 units too far, give it a k/v lip/40
or
if u want a 128 units wide door slide 100 units, give it k/v lip/28

this default lip of 8 makes it difficult to explain...

hehe, its very confusing at first, but eventually we all get it.

Wacko wrote:give the func_door a key/value of lip/##
## is the number of units u want it to stop earlier minus 8
normally a door slides as far as it is long minus 8, which is because the default lip value is 8.
so:
if it slides 32 units too far, give it a k/v lip/40
or
if u want a 128 units wide door slide 100 units, give it k/v lip/28

this default lip of 8 makes it difficult to explain...

I (think) I get it, I'll go try it right away...
Thx

Thx a lot!
After guessing, testing and a bit of twinkering I got it working like a charm!