Page 1 of 1
Door question
Posted: Tue Jan 20, 2004 5:04 pm
by dooguesgoober4
Is there any possible way to make the door open upwards like a manhole cover or just like a door that is laying on the ground????
Posted: Tue Jan 20, 2004 6:25 pm
by Yarik
Yes, it is all possible.
Just add the origin to where you want the door hinge to be.
Posted: Tue Jan 20, 2004 7:18 pm
by dooguesgoober4
Okay...whenever i do that and try to open the door, it just slides along the floor......
Posted: Tue Jan 20, 2004 7:44 pm
by Shortricci
Are you using func>rotatingdoor?
It sounds like your using func>door
- Ricci
Posted: Tue Jan 20, 2004 8:54 pm
by diego
We just covered this a couple of days ago:
I've never seen Func_Rotating Door rotate on any axis other than Z. But it can be created through scripts relatively easy. Check out this forum thread and the following link for the .zip file. It has a .map and .pk3 file with lots of door examples.
/forum/viewtopic.php?t=5586&highlight=door+tutorial
http://pages.sbcglobal.net/tltrude/Temp/door2.zip