Page 1 of 1
Rain In Buildings?
Posted: Thu Jan 22, 2004 5:40 pm
by chrisjbooth2001
Rain in buildings?
Please help!!!
I've tried everything! If you think you can help please contact me on
chrisjbooth2001@hotmail.com
I can send you the .map over email for you to look at..! cheers!
Chris
Posted: Thu Jan 22, 2004 7:13 pm
by Bjarne BZR
Dont put the func_rain brush inside... and the outside func_rain brushes must be some units away from walls as well because the rain is generated inside the func_rain brush, but it may end up inside it after falling.
Posted: Thu Jan 22, 2004 7:16 pm
by chrisjbooth2001
Hey,
I did all that before and it didnt seem to work, could i email you the .map file and you take a look?
If not, how many units would you suggest it being away from my building? and can i have rain above the roof? Cause on my current map, you can reach a roof
Posted: Thu Jan 22, 2004 7:29 pm
by Bjarne BZR
chrisjbooth2001 wrote:Hey,
I did all that before and it didnt seem to work, could i email you the .map file and you take a look?
Sorry, don't have the time to do that.
chrisjbooth2001 wrote:If not, how many units would you suggest it being away from my building? and can i have rain above the roof? Cause on my current map, you can reach a roof
Depends on how the rain is configured... about 16-32 units... start somewhere around those values and calibrate it if its not good. And yes, you should be able to have it over the roof ( a few units off ).
Re: Rain In Buildings?
Posted: Thu Jan 22, 2004 8:07 pm
by Gen Cobra
chrisjbooth2001 wrote:Rain in buildings?
Please help!!!
I've tried everything! If you think you can help please contact me on
chrisjbooth2001@hotmail.com
I can send you the .map over email for you to look at..! cheers!
Chris
Well let me tell you right now if you think you did it right then this is the problem.
You can't clone func rain brushes. I don't know why or how but the editor links them together for some reason. Make each rain brush one at a time. Also make sure they are far enough away from the buildings so the rain doesn't drift in.
Posted: Thu Jan 22, 2004 8:20 pm
by chrisjbooth2001
I didnt use the clone button. Is copy and paste ok?
Posted: Thu Jan 22, 2004 8:50 pm
by Bjarne BZR
Don't think so, no.
Posted: Thu Jan 22, 2004 9:20 pm
by Gen Cobra
chrisjbooth2001 wrote:I didnt use the clone button. Is copy and paste ok?
Don't do either. Take the time to make each rain brush.
Posted: Fri Jan 23, 2004 11:29 am
by indiana_tim_d
it also doesn't work (you get rain inside buildings) if you select all the rain brushes at once then do the func_rain. it all has to be done individually.
Posted: Fri Jan 23, 2004 6:14 pm
by chrisjbooth2001
That could be the problem, thanks