Page 1 of 1
Applying textures over textures
Posted: Sat Jan 24, 2004 2:20 am
by hogleg
I was wondering if putting a texture over another texture causes engine to have to draw the textures twice on the same brush?
Sometimes I decide to change a texture and I just apply it over the old 1.
Is that a bad thing to do?
Posted: Sat Jan 24, 2004 6:28 am
by bighoss
I dont think it does anything bad. Cause when I change textures I just do that and it doesnt seem to mess anything up. I dont think your putting textures on top of the other. Your changing it not adding on top.
Posted: Sat Jan 24, 2004 12:57 pm
by Bjarne BZR
Applying a new texture replaces the old one, so you do not need to worry. Such a problem will only appear if you have 2 brushes in the same spot, and from your post I take it that that is not the case...
Posted: Sat Jan 24, 2004 8:15 pm
by hogleg
Thanks, I was worried about that.
