.Map :: MoHAA Mapping

Hey everyone!

I am making a map and i have compiled it three times to test to see if things are ok. After a few compiles I wanted another compile to see it ingame again because I had changed some things and I wanted to see if they were ok in game. When i compile my map now, it brings up the dos mode and really fast it zooms all this writing and goes off like it doesnt give a shit. It then goes off, it normally takes atleast 10 seconds to load it all anyway Im like.. huh ok.. and I go ingame to test it and it is there (from the previous compile test i did) and I load the map up, and nothing has changed since I last compiled it.

I have tried renaming the map, I have caulked everything that I added since it worked ok and retextured them, and tryed changeing some textures and stuff.

Please help Im also a n00b at mapping soo go easy on me!

Turn the pauses back on so you can see what it say at the end of each step.

Hey, thanls

It works now, turns out the erro was my terrain was to high... all sorted now, thanks very much m8