Page 1 of 1
ARCHES (Curves)
Posted: Thu Feb 19, 2004 3:20 am
by {UDT}OS3.Barney_Fife
O carbongraphx Video tut web site is shows how to make ARCHES but when i go to make Inverted Endcap it dose not work right on the tut it shows the sids but on mine it just shows two, one on each side a little box that you can see through.help plz
Posted: Sat Feb 21, 2004 1:06 am
by hogleg
Don't u hate it when no one responds?
The exact thing happened to me when i took that tut.
But the second time I did it it came out perfect.
I think I had left a vertice were the endcap sits, make sure u move all vertices to the edge.
good luck
Re: ARCHES (Curves)
Posted: Sat Feb 21, 2004 1:16 am
by wacko
{UDT}IC3OS.Barney_Fife wrote:... it just shows two, one on each side a little box that you can see through.help plz
viewtopic.php?t=6760&start=0&postdays=0 ... ws+columns is, where I explained what to do.