.Map :: MoHAA Mapping

Well I was searching for barb wires and trigger hurts and I found a lot of stuff but nothing related on a trigger hurt.

Are the trigger hurt a good stuff for making barb wires, I tried to put a triger use on my barb wire model and it works because it cause damage to the player (default 10 units as says the editor) but I still can cross the model an the trigger.

Is there anyway to make that trigger_hurt solid? or have I to put a caulk or nodraw brush inside of the trigger to stop players?

Well I hope that is a way of making that withaut scripting cause I found a lot of stuff for making that scripting but nothing about a trigger hurt and making it just mapping.

Sorry about my bad english and thankyou for your atemption.

use a metal clip brush that shud solv your prob and have the trigger covering that.

Well, I tried it and it works, thankyou, but there is a little problem. Bullets cant get through the metal clip and it?s sound is a little bit unreal.

Well it is not a big problem but if someone know another way to do it please say it here

player_clip is what you are after

You got trigger_hurt to work? Far as I know, it does not work.

Well thank you Bjarne, you?re truth that was what I was looking for.

And yes tltrude, my trigger hurt works properly, can send you the map if you want, is a little testing map with only a sky box and three walls.

Well I also use to read that all of you guys are using the moh aa to map and test. I?m testing it in Breakthrough and it is possible that this is the reason for what it works for me and not for you.

Thank you all again. you are the best heheheh.

Ok, well I don't think it works in Mohaa or Spearhead.

Well dear Tom you were truth again.

I tried it in Spearhead and the map crashes my game.

Well don?t know why wanted to try it hehhe as your words are almost always truth hehehehe.

Now I will have to learn another way to make my barb wires work ?cause I want my maps to work in Spearhead but I think there is a lot of stuff about it by here.