.Map :: MoHAA Mapping

Howdy Do All,

I have 2 little probs I hope you can help me with.

Prob 1: I have some oil barrels stored on a second floor of a room. The barrels look ok and when you shoot them oil pours out till it has all gone. the problem is the oil that pours out also comes through the ceiling of the room below how can I make it so it flows onto the floor only?

Prob 2: I made several rotating doors in rooms on my map. compiled the map tested all doors everything worked fine. I then decided one of the doors would be better if it was taken out to leave an open doorway. however none of my doors are showing up in Radiant either in 2d or 3d view they are there still when I compile the map again? they are all func rotatingdoor. I havent intentionally filtered them out. being new to this I may have accidentially done that but I dont know how lol. how can I get them to show up in radiant so i can edit them?

OK quick update I just re-loaded radiant and my oil drums don't show up now either so they must be filtered out is there a way to turn all filters off again so everything shows up?

Many thanks for any help given

OK I sorted the doors and barrels out I had the entities filtered out. pressing ALT & 2 sorted that out. I should have checked radiant help 1st

I am still having problems with the oil leaking through the floor any help with that will be mucho appreciated thanks

Make the lower half of the barrel fake. Might be better to make that lower half with jagged edges, becaue it will be left behind when the top half gets blown up.