Page 1 of 1
My map doesn't load the script!
Posted: Thu Dec 19, 2002 3:39 pm
by mohaa_rox
My map doesn't load the script! It is called test_bombing. My script is also called test_bombing.scr. When I load the map, the script doesn't run! I even tried to pk3 it. Can someone help?
Posted: Thu Dec 19, 2002 3:51 pm
by jv_map
Check the console for error messages.
If you have too many make a logfile by typing 'logfile 2' in the console before starting the map.
Posted: Sun Dec 22, 2002 11:11 pm
by UBER_SOLDAT
you get that if theres an error in the .scr. make sure you havent made any easy mistakes, like putting 2 $$s for a targetname or something.
type editscript in the console, then cancel individual threads out with /* at the start and */ at the end. then save, and type restart in the console. keep doing that until the script loads, then use /* ... */ again, but for each line. after a while youll find out which line has the error.
Posted: Mon Dec 23, 2002 2:35 am
by mohaa_rox
Ok, that's all. There are errors in my script that's why. Checked them in the console. Some typing error.
