.Map :: MoHAA Mapping

I bet youve seen this before but I make a rotating door with an origin like the tut says and when I hit func_rotatingdoor it says "entity not created"

lol, Ive got to laugh at myself for this one, it was still a sliding door,
ill leave this up incase another noob needs help.

After all, its better to learn from someone elses mistake than your own... I think...

In shame and so that this post is not wasted, I will give each of you a chance to post "noob" below.

YES! STEP RIGHT UP FOLKS! POINT AND LAUGH AT THE NOOB!!!! ONLY ONE POST OFFER, DONT MISS OUT!!!

Don't be so hard on yourself! Trust me, we (the veteran mappers) have all been there. We ALL have done silly things like that at one point or another...

yea,i have better luck wit sliding doors also.lol

Yep. whenever you see "entity not created" it means it has to be ungrouped before you can redo it. Don't forget about setting the angle for your rotating door (number buttons). It has to be set to one of the directions the a player will face to open it.



Notice that no angle is set for doors facing to the left and right. That is because the default angle is 0, which is right for doors facing that way.

blue60007 wrote:Don't be so hard on yourself! Trust me, we (the veteran mappers) have all been there. We ALL have done silly things like that at one point or another...

And some of us still make silly mistakes, from time to time. It happens to me a lot, that's for sure...

NOOOB! NOOB! HAHHAAHAHAHAHAHAHAHAAHAHAHAHAHAHHAHAHA *points and falls over laughing*

ok ok seriosuly, it happens. mistakes are how ya learn.

Ouch. You're going to have to give me some cream for the BURN you just handed out.

j/k

ive made 2 or 3 maps filled with func_door's

I tend to forget after not mapping fo a few months that I want to be using func_rotatingdoor....

thank god for replace all.