local.guy
Posted: Tue Jan 25, 2005 8:13 pm
I have a local.guy, and he wont run to my node while using:
local.guy runto truck_ai_node
Any suggestions?
local.guy runto truck_ai_node
Any suggestions?
Page 1 of 1
Posted: Tue Jan 25, 2005 8:48 pm
well... you did make pathnodes to it or made sure it's close to him, or made a bunch of pathnodes close together so they connect? is his AI on?
Posted: Tue Jan 25, 2005 9:44 pm
Lol, SP is so damn complicated 
It could be he needs pathnodes to it, but it aint far away (just about the corner 200 units or so)
And he shoots at me, so i'm pretty sure his AI is on
I'll try some extra pathnodes, if not i'll report back...
It could be he needs pathnodes to it, but it aint far away (just about the corner 200 units or so)
And he shoots at me, so i'm pretty sure his AI is on
I'll try some extra pathnodes, if not i'll report back...
Posted: Wed Jan 26, 2005 5:43 am
local.guy runto $truck_ai_node maybe it is because you missed putting in the $
Posted: Wed Jan 26, 2005 12:27 pm
Its ok, the pathnodes was the problem 
and about the $, i thought it was odd i didnt need is too
and about the $, i thought it was odd i didnt need is too
Posted: Wed Jan 26, 2005 3:49 pm
pathnodes seem to not need the entity operator sometimes, but sometimes they do in the exact same command just a single line down :S i've never understood it.